DD-WRT Linux Distribution für Router

Installation auf AsusWL500g (deluxe): http://wiki.openwrt.org/OpenWrtDocs/Hardware/Asus/WL500GD

TFTP Installation notes

Enable Failure Mode - remove the power, press and hold the reset button while returning power. Within a few seconds the PWR LED starts flashing slowly (once second on, one second off). Release the reset button and continue.

You should be able to ping the unit:

ping 192.168.1.1 

/!\ Note, the ASUS WL-500GD doesn't revert to the 192.168.1.1 address when starting the bootloader, but uses the LAN IP address set in NVRAM. Try this address if you have difficulties.

(!) If you can’t ping the unit retry enabling "'Failure Mode'", even if the LED is blinking it sometimes does not respond. Turn it off and then on first. You can even do a factory reset.

Send image with TFTP:

tftp 192.168.1.1
tftp> binary
tftp> trace
tftp> put openwrt-xxx-x.x-xxx.trx 

Tipps und Infos

Resetten des NV-Ram

mtd erase nvram 
reboot 

DD-WRT (last edited 2006-05-11 22:32:23 by p5487807A)